4
« on: October 13, 2020, 05:26:04 AM »
I have a Sherline 5410 (metric) milling machine running through a cheap Chinese breakout board by Bitsensor.com model BSMCEO4U-PP. I have all the axes and pin setup correcting where I can jog back and forth through Mach3. However; my problem is setting up my homing/limit configuration. I have looked at many online tutorials and some of them can be a little confusing to a person unifiliar to Mach3. Dose anyone know the proper setup for homing/limit configuration for a Sherline Mill or should I say does anyone know of a good tutorial step-by-step guide for a newbie to Mach3?