Hello Guest it is September 21, 2023, 07:40:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Andrei Cristian

Pages: 1
General Mach Discussion / Re: Hall of shame
« on: October 10, 2020, 02:51:42 PM »
Just a little off thread comment and that refers to users of pirated licenses.
We have been rather discrete about those users and address accordingly.
If a user has the gall to use this forum knowingly using a pirated license they won't be here for long.


Why? 1st you're selling a 2004 software for almost 200 dollars, to call it stupidly expensive would be an understatement, and there are people buying CNC's from websites like AliExpress that include the Mach3 software, obviously a pirated one.

There are countless people that i know that use pirated software not because they take pleasure in abusing the developer but simply because they cant afford it.

And if anybody would ask me if the should pay ~200 USD for a ancient piece of software id advise pirating it, if however that person uses the software to make money than i agree they should pay for it.

There are countless people that simply cant afford the software or are just interested in learning.

And i sincerely think they hurt nobody, if anything they might one day advertise the software to somebody that would be ready to buy it.

And again, for the 3rd and sure not the last time, charging almost $200 for a 2004 software, one wont be far from truth if he called you crooks.

General Mach Discussion / Re: Help a newbie
« on: October 10, 2020, 01:16:17 PM »
found the folder but i have no idea which one deals with the machine homing

General Mach Discussion / Re: Help a newbie
« on: October 10, 2020, 11:33:22 AM »
So, i managed to figure out how to toggle the spindle so that's fine now.

General Mach Discussion / Help a newbie
« on: October 10, 2020, 10:39:31 AM »
Hello everybody, i just bought a 6040Z, this wonderful chinese machine comes with mach3, now, this program beats me, hard, i almost hate it, i couldn't find help anywhere else so i decided to make a post here.

My problems are:
the machine homes X and Y before Z, which caused me to brake a almost brand new end mill
the spindle speed max is defaulted to 8000 even though my spindle can do up to 24k

I only hope there's somebody here that can help me, cause i've spent two days already trying to figure it out and all i found was people having trouble setting their limit switches, which i dont (yet) have

Thank you.

Pages: 1