Hello Guest it is March 29, 2024, 05:11:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bgagliana

Pages: 1
1
General Mach Discussion / How to slave X to Z and Y to A axis in Mach3?
« on: October 06, 2020, 11:24:45 AM »
Hello all

First time post here, I've scoured the internet and manuals for the answer but stumped..

I'm building a 2 axis hot wire cutter (X + Y) with stepper motors. I've slaved the Y to A axis (vertical motion) with no problem but no success slaving X to Z for horizontal motion.

Using a Sainsmart 4-axis USB CNC Controller Card

Any tips or tricks to slave X to Z is greatly appreciated.

Thanks in advance


Pages: 1