Hello Guest it is April 20, 2024, 01:18:48 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - pgehbauer

Pages: 1
1
General Mach Discussion / Re: Is MakerCam.com site broken? Are there any alternatives?
« on: October 03, 2020, 08:03:56 PM »
Neither Makercam nor the alternate site work. The alternate site seems to have been discontinued.

Is there an alternative that you might recommend - my goal is to convert SVG to GCODE as described in https://youtu.be/8kfNAhM_NLg

Thanks!

Peter

Pages: 1