1
General Mach Discussion / Re: mach3 lathe
« on: March 21, 2021, 12:52:46 PM »
Update on my screw cutting problem “SOLVED”
Finally she is screw cutting in sync mode
All it was was the motion controller uc400eth setting it was set for an encoder which it has
Not got , well chuffed now,just finished a batch of M33 x 3.5 pitch internal and external threads successfully
Finally she is screw cutting in sync mode
All it was was the motion controller uc400eth setting it was set for an encoder which it has
Not got , well chuffed now,just finished a batch of M33 x 3.5 pitch internal and external threads successfully