Messages

1

General Mach Discussion / Re: mach3 text engraving issues

« on: September 10, 2020, 10:22:09 AM »

After re checking my settings probably 100 times I finally figured out the z top setting was wrong. but thanks for the reply

2

General Mach Discussion / mach3 text engraving issues

« on: September 09, 2020, 02:31:56 PM »

ive been using the text engraving wizard on mach 3 loader and its been working.
now when I set everything and type what I want engraved and hit cycle start it moves in the y axis where it needs to be then drops down past where I set my z and goes an inch or so into the board im engraving. any suggestions on what is wrong and how to fix it ?