Hello Guest it is April 19, 2024, 08:43:47 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bridgeport13

Pages: 1
1
General Mach Discussion / Re: I am having a problem with a retrofit using mach3
« on: September 13, 2020, 04:48:55 AM »
Yes Z was zeroed

2
General Mach Discussion / I am having a problem with a retrofit using mach3
« on: September 07, 2020, 05:54:20 PM »
When trying to run a program using a wizard my Z will only go in the positive direction. Could this be something in Mach3? My wiring seems to be right and I can control the Z with the page up and page down. It seems to be in the program or something I have done wrong with the Mach 3. Help please

Pages: 1