Hello Guest it is March 28, 2024, 01:51:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - fabiototo

Pages: 1
1
General Mach Discussion / Re: change coordonee x,y,z axis[resolv]
« on: May 01, 2010, 04:07:07 AM »
excuse me

i have find the solution

with the  portable iblock the touch fonction:

fn + F11 and after i can use the number with touch ,jkluio789

I don't know if i have very clear.

Thank you
Fabrice

2
General Mach Discussion / Re: change coordonee x,y,z axis
« on: May 01, 2010, 03:57:59 AM »
Thank you for your answer.
I have tried with a normal compuetr and i see when i make the change with numerical keyboard , tre is no problem.

But when i tried with number up to azerty whit shift , i can't change this.

My problem is, i use a computer portable for milling and i haven't numerical keyboad, i have only the number up azerty.

Have you got a solution ?

Thank you
Fabrice

3
General Mach Discussion / change coordonee x,y,z axis
« on: April 26, 2010, 05:20:44 PM »
good morning,

in old version if mach 3 , it is possible to change coordinate x,y,z axis in the windows  (Alt-1).I remember, i click on the label where i have my coordonate and i change the value .
But in the Version R3.042.038 it is not possible .Why or perhaps i make a mistake ?

Thank you for your help

fabrice
escuse me for my bad english

4
General Mach Discussion / Re: save mach3 config
« on: November 19, 2009, 04:20:00 PM »
THANK A LOT

Fabrice

5
General Mach Discussion / Re: save mach3 config
« on: November 19, 2009, 04:19:25 PM »
THANK

6
General Mach Discussion / save mach3 config
« on: November 19, 2009, 12:42:40 PM »
good morning

does it possible to save all file config for mach3cnc.

thank you for your help

7
General Mach Discussion / mach3 with port usb ??
« on: April 28, 2009, 06:35:09 AM »
good morning

I have a computer who haven't got port //.
Does it possible to use mach3 with port usb ??

thank you
fabrice

8
LazyCam (Beta) / problem with import dxf in lazicam
« on: September 11, 2007, 02:59:37 PM »
good morning , i want to try lazycam but i have a problem when i import dxf.So i start lazicam , i import dxf and the screen is to solidify.
The computer is to solidify and i am to oblige restart my computer.
Do you know why ??
My configuration is windows xp sp2, procesor core duo 1.6, and motherboard p55-mx se
thank you for your help

excuse me for my bad english

fabrice

Pages: 1