Hello Guest it is May 10, 2021, 01:59:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - c3l1n

Pages: 1
Mach4 General Discussion / Touch sensor mounted at side of spindle.
« on: August 19, 2020, 01:11:07 PM »

is it possible to setup somewhere in Mach4 offets of touch sensor? I decided to mount my self made sensor not in spindle but at some offset (to have quick access to measure without changing tool). So what I want is to perform some calculation in TouchOf plugin to substract offsets.

Best regards C3l1n

Pages: 1