1
Mach4 General Discussion / Re: 3D touch-probe with large offset to spindel
« on: September 17, 2020, 01:37:05 PM »
Hi,
sorry for the late reply. Thanks for your answer. I measured the offset between my spindle and the 3D touch probe with a clock as you suggested. I then wrote a custom button script which moves my spindle the specific amounts and re-zeros, this works fine.
But now i have an other Problem i wanted to reset my Probe offset to X0 and Y0 but with the Calibration routine I always get a wrong offset no matter how accurate it is. The only thing I need calibrated from the software is the Radius of my touch probe.
Best regards,
KDRedSmith
sorry for the late reply. Thanks for your answer. I measured the offset between my spindle and the 3D touch probe with a clock as you suggested. I then wrote a custom button script which moves my spindle the specific amounts and re-zeros, this works fine.
But now i have an other Problem i wanted to reset my Probe offset to X0 and Y0 but with the Calibration routine I always get a wrong offset no matter how accurate it is. The only thing I need calibrated from the software is the Radius of my touch probe.
Best regards,
KDRedSmith