Hello Guest it is May 18, 2021, 05:26:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - billpardee70@gmail.com

Pages: 1
Mach4 General Discussion / Z zero
« on: July 26, 2020, 09:13:25 PM »
Every time I set my Z height, when I hit start , it goes straight down and plunges into the wood.  I have to zero my Z height two or three times to get it to work right.  I am tired of wasting wood.

I am using Mach 4 Hobby
PMDX controller


Bill Pardee

Pages: 1