1
General Mach Discussion / THC problems
« on: July 08, 2020, 11:50:17 AM »
My plasma table was working perfectly but I decided to add a Proma THC 150. I hooked it all up and put the proma in TEST mode and mach 3 is recieving the arc ok, up and down signals and mach 3 is making corresponding adjustments to the Z axis (the z axis is going up and down in the DRO) but the physical Z
axis motor is not moving at all. Matter of fact, when the proma is sending input signals none of the axis will move. I tried XYZ jog keyboard commands and the numbers change in the DRO but no movement of the motors........ As soon as I take the proma out of TEST mode and no signals are coming, the XYZ all work perfectly.
This is on a parallel port BOB and the mach 3 appears to be licensed. No limitations.
Any ideas?
Thanks!
axis motor is not moving at all. Matter of fact, when the proma is sending input signals none of the axis will move. I tried XYZ jog keyboard commands and the numbers change in the DRO but no movement of the motors........ As soon as I take the proma out of TEST mode and no signals are coming, the XYZ all work perfectly.
This is on a parallel port BOB and the mach 3 appears to be licensed. No limitations.
Any ideas?
Thanks!