Guest
Show Posts
1
General Mach Discussion / Mach 3 Setup for a plasma CNC
« on: July 06, 2020, 09:34:02 AM »
HI
We have recently built a cnc machine for plasma cutting but are having a bit of a hard time setting up the mach 3 software to work. I cannot find much on the different options for setting up the motors, speed etc and how to do it.
I can get it to move forward , sideways and set the zero points but not sure where to set the size of the table and basically how it works any help would be greatly appreciated.
Thanks
We have recently built a cnc machine for plasma cutting but are having a bit of a hard time setting up the mach 3 software to work. I cannot find much on the different options for setting up the motors, speed etc and how to do it.
I can get it to move forward , sideways and set the zero points but not sure where to set the size of the table and basically how it works any help would be greatly appreciated.
Thanks