Messages

1

Third party software and hardware support forums. / Re: optimum kontroller IV

« on: May 16, 2020, 08:31:31 PM »

Thank you all for your help, I checked the sittings s still as per the installation software it came with port 1_pin_1  as O/P , really was waste of time , i removed the cover for the transformer and found it was wired for 230 not 115 as per the manual. i hooked it to 240vac and here we go everything worked fine. the transformer was giving half the O/Ps was 5VD was fine 6Vdc instead of 12Vdc and 24Vac instead of 48ac

2

Third party software and hardware support forums. / Re: HELP WITH OPTIMUM CNC CONTROLLER VI AND MACH3

« on: May 13, 2020, 10:54:23 PM »

I uploaded pictures in my previous post . i will tap the inputs and inject and verify , will update this post before the weekend thanks

3

Third party software and hardware support forums. / Re: optimum kontroller IV

« on: May 12, 2020, 11:58:35 PM »

board attached,

4

Third party software and hardware support forums. / Re: HELP WITH OPTIMUM CNC CONTROLLER VI AND MACH3

« on: May 11, 2020, 11:20:09 PM »

just acquired this optimum lathe machine, i did set up with the cd coming from industry controls , as per the manuals verified the settings all seems correct still i can not move either axis, i opened the box and found a relay is cutting the power to reach the stepper motor driver from the toroidial transformer ,  is there a specific sitting in mach3 to override this relay but do not see any info for it, as per the manual it says the controller will turn the motors off in case of short or overvolatge but event hing is connected and I can see the limit switches working fine.  any ideas ?  and yes I contacted  Optimuim in Germany directly still did even bother to reply.

5

Third party software and hardware support forums. / Re: optimum kontroller IV

« on: May 11, 2020, 11:16:05 PM »

just acquired this optimum lathe machine, i did set up with the cd coming from industry controls , as per the manuals verified the settings all seems correct still i can not move either axis, i opened the box and found a relay is cutting the power to reach the stepper motor driver from the toroidial transformer ,  is there a specific sitting in mach3 to override this relay but do not see any info for it, as per the manual it says the controller will turn the motors off in case of short or overvolatge but event hing is connected and I can see the limit switches working fine.  any ideas ?  and yes I contacted  Optimuim in Germany directly still did even bother to reply.