Hello Guest it is March 29, 2024, 07:42:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - coyspurs

Pages: 1
1
General Mach Discussion / Re: Demo version
« on: September 20, 2020, 02:00:44 PM »
I hope so, but my laser is a 12v so I think that will cause me problems,  can I get back to you for advice if I need it?
Many thanks

2
General Mach Discussion / Re: Demo version
« on: September 20, 2020, 10:09:49 AM »
Hi, have just ordered a 5 axis board should be here tomorrow, so will get that fitted and be back working. Will be wanting some advice how to hook up a 12v laser so watch out!
 
Mike

3
General Mach Discussion / Re: Demo version
« on: May 01, 2020, 05:00:43 AM »
Ok thanks, out of 15 forums I belong to I have never had to ask basic questions like on this one, Mach 3 is easier than this lol
Hopefully you may now see a picture of the usb board

4
General Mach Discussion / Re: Demo version
« on: May 01, 2020, 01:18:07 AM »
All I have under options is "Quote",

5
General Mach Discussion / Re: Demo version
« on: April 30, 2020, 06:47:45 PM »
Hi, thanks for the reply, can't see where to reply so as to be able to post photo!

6
General Mach Discussion / Demo version
« on: April 30, 2020, 11:40:49 AM »
Hi every one,
Just joined the forum after downloading the demo as advised before purchasing a licence.
I am a 66 year old from the UK just trying to find a retirement hobby. Building my own cnc router and now ready to get it started!
I have a Mach 3 usb interface board, with 6650 drivers and nemo 23 motors. I cannot seem to communicate with the board, although the usb port sees something as the boards red light is blinking. After investigation i clicked driver test in the Mach program and it is saying "No driver sensed installed". Tried installing Special driver still no good. Might have made an error in downloading the parallel port driver? Running Windows 10 Ver. 1909.
Any ideas where i am going wrong? Many thanks in advance
Mike 

Pages: 1