1
General Mach Discussion / Re: Program Just stops
« on: November 13, 2023, 09:52:44 AM »
I honestly cant remember operating system I want to say it is windows 10. I will check that, I know the screen saver come on. It can happen on very first op. I am also going to find a shielded usb cable or try the Ethernet cord again. Forgot to add sometimes at the end of a program it start to retract z and just stops as if it was already back to G28. I also notice while jogging when I stop moving the axis it makes a volant noise when it stops. I did not think in Mach3 you can jog both X and Y at same time but sometimes it lets me and others it will not do it. Thinking maybe I need to reload Mach3 but it will have to wait until after I finish this order.