Hello Guest it is October 20, 2021, 05:52:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Maxxk9

Pages: 1
1
General Mach Discussion / Mach 3 4th axis display
« on: March 19, 2020, 08:26:10 PM »
I am setting up a rotary axis on my plasma cutter for tube profiling. Unfortunately,  I cannot figure out how to get Mach 3 to show the 4th axis on the screen. I have finished enabled and configured the A axis, but it will not show on the main screen. Any ideas?

Pages: 1