Hello Guest it is March 28, 2024, 09:46:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bgasser

Pages: 1
1
General Mach Discussion / Re: homing issues
« on: March 18, 2020, 12:00:41 AM »
This has been resolved.

I had another machine profile that I tested the "ref all home" button. That button worked properly so I loaded and copied the vbscript from that profile to the defective profile.

I am not really certain what was defective in the vbscript, because they had the same code, but copying the code did work.

Thanks!

BG

2
General Mach Discussion / Re: homing issues
« on: March 13, 2020, 02:39:18 PM »
That is not it, machine is not connected to the internet at all.

Thank you for the input.

BG

3
General Mach Discussion / homing issues
« on: March 13, 2020, 12:23:50 PM »
I am running mach 3 connected to a machine with a Gecko g540. For limit switches I am using cnc router parts proximity swiches.

The machine has been up and running for about 18 months without any major issues. Homing and limit switches were working fine until about 3 weeks ago. At that time when I would home the machine the y axis would home properly but the x axis would move to the limit switch, trip the switch but not back off to a home position. I have checked the configuration and it has not changed.

Any idea what could cause this issue? I have an extra proximity switch that I could change out, but it seems that something changed elsewhere due to the fact that the limit switch will trip.

Thanks.


BG

Pages: 1