Hello Guest it is March 28, 2024, 03:10:51 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rfhall50

Pages: 1
1
General Mach Discussion / Re: Sorry to ask, but ... LIMIT SWITCHES
« on: April 30, 2020, 09:16:44 PM »
Thank you for your quick response.  Based on what you told me, plus a graphic I found, I think I need to recheck my setup.  Thanks again.

Bobby

2
General Mach Discussion / Sorry to ask, but ... LIMIT SWITCHES
« on: April 30, 2020, 12:57:49 PM »
I hate to ask a really ROOKIE question, but ...

Are limit switches strickly a break in CONTINUITY, or do you need to supply voltage?

Had a problem testing the Estop. Can't seem to get it to work using a break in continuity only.  I understand N/C vs. N/O.  I have tried GROUND to ESTOP connection using only a break in continuity. Getting a direct answer to the question above has been difficult.  (Broke a coupler because it wasn't working).

I am using a SainSmart 5 Axis BOB.

Thanks in advance.

Bob

3
Mach3 under Vista / Mach3 on Win7 - Labels
« on: April 29, 2020, 07:48:49 PM »
There is no text for the buttons.  Example: Reset button is Red, but no text.  Same for other buttons.

Any Ideas ???

Bobby

Pages: 1