Hello Guest it is March 28, 2024, 02:18:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mert

Pages: 1
1
Hello everyone I am trying to make the same part numerous times I have tried starting my Z at a new -zero and tweeked the numbers but it just wont do it.I see on Mach4 they have a run multiple parts button but have been using mach 3 on lathe and router for a while hate to change but if need be I can Thanks   all help greatly appreciated    Mert

Pages: 1