1
Mach4 General Discussion / Re: Mach4 Parallel Port Axis Setup
« on: February 11, 2020, 07:38:01 AM »
Hi Tweakie,
Here's the new picture.
I tried out those settings and they don't seem to work. I went back to mach3 to try there, but it also didn't seem to work there when
I switched the y step to an 8 (from 7).
I have the enable pins exactly the same in mach3 so that's promising, but I wasn't able to find where to use the Enable pins in mach4 which may add to the problem. If you
could let me know where that setting is, that would be great
Do you think it could be bad wiring or maybe something else that I've configured incorrectly?
Thanks for your help!
Aaron
Here's the new picture.
I tried out those settings and they don't seem to work. I went back to mach3 to try there, but it also didn't seem to work there when
I switched the y step to an 8 (from 7).
I have the enable pins exactly the same in mach3 so that's promising, but I wasn't able to find where to use the Enable pins in mach4 which may add to the problem. If you
could let me know where that setting is, that would be great
Do you think it could be bad wiring or maybe something else that I've configured incorrectly?
Thanks for your help!
Aaron