1
HiCON Motion Controller / Re: HiCon Integra: Motion Buffer Packet Loss? Unable to ARM drive code=355
« on: March 02, 2020, 12:47:12 PM »
Unfortunately replacing the Ethernet cable did not yield results. At this point it seems the "activation" file may also be corrupt. The error I received this morning is attached (unable to ARM drive code=355). I can load the software and profile but the E-stop button on the screen appears to be activated while no E-stop functions are tripped. I read in other forum discussions that the "Activation key" may be corrupt.
Details for the error received this morning are attached. Until this is cleared I cannot proceed:
original board ord#: 44232
Is there a definition list of error codes. I'm actually not sure if this is a HiCon error code or Mach error code so please forgive me if I'm inquiring up the wrong tree.
Details for the error received this morning are attached. Until this is cleared I cannot proceed:
original board ord#: 44232
Is there a definition list of error codes. I'm actually not sure if this is a HiCon error code or Mach error code so please forgive me if I'm inquiring up the wrong tree.