Hello Guest it is March 29, 2024, 05:08:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - milkof

Pages: 1
1
General Mach Discussion / Re: Set tool length
« on: May 24, 2006, 01:00:29 PM »
There is a video that will tell you one way to do a tool setter... After you have tooled at that you are free to post here and I will help you get it working the way you would like. There are MANY ways to set one up...


Thank you and look forward to getting it working for you
Brian


Hi I saw a video but i have a problem to understand whit tell.
For me is more simple read.
which is a many wais to set one up.

regards Milko from Italy

2
General Mach Discussion / Set tool length
« on: May 23, 2006, 04:22:40 PM »
Hi, I have a question for you.

I have a sensor for set a tool length but I don’t know how can use it.

Is it possible make a automatism for use it?

There Is a macro?

Could tell me more about?

 

 

Regards

 Milko

Pages: 1