Hello Guest it is April 18, 2021, 01:01:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - C1rcu17

Pages: 1
1
General Mach Discussion / Re: X axis not working with code
« on: January 24, 2020, 08:23:33 AM »
Update:  I managed to get it working last night.  IDK if it is the cause of my new breakout board or some other issue but I increased my delay time from 0uS to 5uS and it works perfectly now.

2
General Mach Discussion / Re: X axis not working with code
« on: January 23, 2020, 11:17:20 AM »
I will attach my gcode later but this happens even when I manually enter a g0 x1 command.

3
General Mach Discussion / Re: X axis not working with code
« on: January 23, 2020, 10:51:46 AM »
When I jog it everything is accurate. Everything is the same as before my teardown where it was working perfectly.

4
General Mach Discussion / X axis not working with code
« on: January 23, 2020, 10:24:07 AM »
Hello,

Im using the Aspire software to create my codes, and for some reason when i start the code the X appears to be moving in mm instead of inches but the Y and Z are moving just fine.  It also jogs just fine, but also when I put in G-code for any movement in X it seems to move small increments and displays the coordinates as if it moved an inch when again it only moved about a mm.

Any suggestions?

Pages: 1