1
Mach4 General Discussion / Mach4 Plasma move Z+ after cut
« on: January 20, 2020, 01:26:33 AM »
Hello,
Is there a possibility that the Z axis moves up to a certain value after cutting a contour (eg + 50mm). To be at a sufficient distance from the sheet metal so as not to get caught anywhere. Could you program that into the M5 macro and if so how?
Thank you so much
Is there a possibility that the Z axis moves up to a certain value after cutting a contour (eg + 50mm). To be at a sufficient distance from the sheet metal so as not to get caught anywhere. Could you program that into the M5 macro and if so how?
Thank you so much