1
General Mach Discussion / Re: Mach3 new user, help with laser.
« on: January 15, 2020, 05:57:32 AM »
Ok, thanks. I've just bought Mach3 which was a bit more expensive than I felt comfortable with but I was in need of it. This means that I will probably be using the software for some time before I start looking at Mach4.
I can see that Mach4 has a much better/newer design which is tempting but do I need some extra hardware, not counting the controller board? Think I've read somewhere that you need an external control for moving the different axis around. This might be info from an uninformed user so I'm unsure if I should trust it or not.
/Mathias
I can see that Mach4 has a much better/newer design which is tempting but do I need some extra hardware, not counting the controller board? Think I've read somewhere that you need an external control for moving the different axis around. This might be info from an uninformed user so I'm unsure if I should trust it or not.
/Mathias