Hello Guest it is March 28, 2024, 04:15:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tntcarvings

Pages: 1
1
its a NVUM Ver 2

2
using a  a usb controller - win7
but will close everything running that I can and try - thanks

3
My motors are tuned and calibrated awesome and run smooth when using the key board -
but when I run a gcode file everything sounds bad and struggling.
it seems to run the file ok fro as long as I let it run.
tweaked here and there but end up at the same tuned numbers
am I missing something in the settings or a bad card when running a file?

4
General Mach Discussion / Re: Problem with Mach3 and nvum V2 usb
« on: December 10, 2019, 10:51:28 AM »
I had directions to place the dll in the plugin folder as well as the main mach3 folder - but I'm using win 7 pro - it may be worth a try if you didn't - also my dll that I'm using is a 3.o version from the novusun web site

Pages: 1