Messages

1

General Mach Discussion / Re: G28 G91 Z0.

« on: December 07, 2019, 09:55:29 AM »

(Side note, also noted that in the GCode glossary in Mach3, it says not to have G28 G91 on the same line......??  Why not???)

Did you get an error saying something like "you can't use two g-codes on the same line with the same axis values? I had a similar problem where the program crashed at:

N2030 G91 G0 G28 Z0.

Solution was just to put the G91 and G28 on separate lines. I guess the problem is it's trying to go home and Z0 at the same time.