1
General Mach Discussion / Soft limit setup?
« on: December 07, 2019, 12:03:25 AM »
I need help setting up my values for the soft limit. So when I home reference all it goes to the bottom left corner of my table. If my table goes 30"+ in X, Y directions what would I put as my soft limit values?
I don't want it to travel to the left or towards me any further.
Is z referenced from the top of the table surface when setting up the soft limit for Z?
I don't want it to travel to the left or towards me any further.
Is z referenced from the top of the table surface when setting up the soft limit for Z?