Hello Guest it is March 29, 2024, 05:14:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - lesliejr

Pages: 1
1
General Mach Discussion / Re: 4th axis issue (newbie)
« on: November 14, 2019, 06:38:30 AM »
Mr Graham, thanks for your help. I checked the recommended settings and everything seemed fine. I then reinstalled the mach3 programme and redid all the settings. Now I'm getting the 4th to move with the x-axis key. Is it possible to have the 4th operating independently?

Another issue I would like some assistance with is accuracy. the steps were done using the auto function in mach3, I did it for 10mm /1cm however, when I send a file to cut I'm off by 25mm less than my desired size. The manufacturer settings are way off I'm using aspire to generate my G-code. is there anything I am overlooking here.

2
General Mach Discussion / 4th axis issue (newbie)
« on: November 03, 2019, 07:44:43 PM »
Hi, I recently bought a CNC router with the rotary attached to the frame. I'm learning the machine in steps so I've only used the XYZ axis and all went fine. now that I am more confident to use the 4th axis rotary I can't get it to turn. I've watched a lot of videos and tried to follow suit but it got me nowhere I'm using mach3 the position remains 0.000 when i try to jog on screen.

can anyone render some help to a newbie to this exciting field       

Pages: 1