Hello Guest it is December 05, 2021, 09:57:05 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - boarboar

Pages: 1
1
I loaded updates for Mach III mill and now I’m having these problems:
1) When the direction of cutting in the x-axis reverses the feed rate briefly slows then picks back up to normal which leaves burn marks in my wood.
2) The jog speed has slowed down to half or less than before even though it is set at 100%
3) The screen size has been reduced like when you change the screen resolution to a higher setting.
Thanking you in advance.

Brian

Pages: 1