Hello Guest it is March 29, 2024, 09:53:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Beer1970

Pages: 1
1
VB and the development of wizards / Re: Turning Wizard
« on: March 12, 2020, 06:58:23 AM »
Thanks. I got a npn switch. Can you help me with the pin and ports please. I have it wired to the OV and 6-24V and pin 14 on input control ports. 

2
VB and the development of wizards / Re: Turning Wizard
« on: March 11, 2020, 07:15:36 AM »
Thank you. So if I change the PNP TO A NPN IT WILL WORK? I AM NOT SO CLUED UP ON ELECTRONICS.

3
VB and the development of wizards / Re: Turning Wizard
« on: March 11, 2020, 05:52:40 AM »
Hi. I have a Mach 3. Motion card
MKX-IV
Usb conection

4
VB and the development of wizards / Re: Turning Wizard
« on: March 10, 2020, 10:18:08 AM »
Good day.I have a inductive proximity switch fitted to my lathe with a Mach3 mod. It is a AE1/AP-1A.I want to use it foe speed and threadcutting. It is set up on my spindel to read once per revolution. Can you help me with the wiring and setup on pins and ports please? It is a PNP switcj.with 3 wires. Brown Black and Blue. Thank you

5
VB and the development of wizards / Turning Wizard
« on: January 15, 2020, 01:54:54 AM »
Good day.
Can I get info how to write my own wizard.
From scratch. FOR DUMMIES. ME as the dummy.
Thanks

6
Hi.
Have you found any info on writing a wizard for Mach 3.
I want to write a few wizards for turning bullets.
I have been doing cnc programing for a bit.
I need some help for dummy. ME
Thanks
Beer

Pages: 1