Guest
Show Posts
1
General Mach Discussion / Nothing Happens when I hit OK in Motor Calibration
« on: October 12, 2019, 11:53:51 AM »
Hi,
Any suggestions for what could be going on here?
My motors are jogging fine but when I go to set steps per unit and tell it to move a distance and hit OK then nothing and there is no jog functionality until I hit RESET.
Any suggestions for what could be going on here?
My motors are jogging fine but when I go to set steps per unit and tell it to move a distance and hit OK then nothing and there is no jog functionality until I hit RESET.