Hello Guest it is December 11, 2019, 07:01:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - carlthomsen

Pages: 1
1
CS-Lab / Re: CSMIO/IP-M and Mach3 Enable output issues
« on: October 08, 2019, 04:43:57 AM »
The Enable output in Mach3 lights up.

2
CS-Lab / CSMIO/IP-M and Mach3 Enable output issues
« on: October 08, 2019, 04:25:17 AM »
Hi,

I'm trying to connect a Clearpath SDSK servo which requires a enable signal from Mach3 to energize it.

I have hooked up +24V to Pin9 and 0V to Pin22 (power for the outputs).

I'm using Output0 (Pin10) on the CSMIO and Port10 as the port.

I don't get any output signal. What am I missing?



Cheers,

Pages: 1