1
PoKeys / Re: Setting error inputs
« on: February 17, 2020, 05:50:05 AM »
Hi
I use output 3 for testing.
You have to short error input to the ground (or to 5v, it depends on your driver) and check the red lamp (Output signals, Diagnostics tab). Test error inputs one by one, and if everything works, change from output 3 to reset.
I use output 3 for testing.
You have to short error input to the ground (or to 5v, it depends on your driver) and check the red lamp (Output signals, Diagnostics tab). Test error inputs one by one, and if everything works, change from output 3 to reset.