Hello Guest it is March 28, 2024, 07:30:19 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - walker

Pages: 1
1
General Mach Discussion / Re: demo
« on: April 12, 2006, 06:13:14 AM »
this has worked some what. i itried swaping but that didn't work, but it worked when i swaped back again. thank you.

2
General Mach Discussion / Re: demo
« on: April 07, 2006, 09:23:04 AM »
i have reinstaled mach 3. i got my missing motor tuning  back . i have redone the back lash settings as it seemed to have something to do with this. it did much the Same\me thing, it  moves slowly on pressing a direction key, the distance is always the same . it then moves to any distance on comand but if i Change direction it crawls back stops then can be moved in jog g1. i have found if i an tick the backlash  i can be jogged and moved with no problem. then after moving it a bit i re tick the box and it moves taking up the small amount of backlash. i have checked the accuracy of the moves back and fourth with g1 and its fine. i have run a couple of small blocks repeatedly and have no probs. after homing  and setting the tool. i wont know if it will require the same to get it to run next start up. i have another problem with the g code generated in bobcad. the drawing looks fine and the post looks good but when i load it in mack3 i have the generated code it the graphic and when an arc is in i have lots blue circles mixed in. the machine tries to copy these and screws up. bit depressing. i run a full size mill with bobcad and fanuc 6m post.  i have tried the Mach3 post but get Heep's of OD ball graphics. the best i can come up with is fr fanuc 10t post.

3
General Mach Discussion / Re: demo
« on: April 06, 2006, 11:45:41 PM »
i must have a major problem . i have not ganged any settings and it was running fine. now i have no jog . and when ii use inc jog [press and hold the shift key and the arrow for dir of x or z the motors crawl away even if i release the keys. when they stop i can make the move at 100% but if i reverse then they crawl back again befor i can make a proper jog. also i have lost the moror tuning page. i had the system running fine, even ran a couple of short files but all has stuffed up now. any ideas.

4
General Mach Discussion / demo
« on: April 06, 2006, 11:30:12 PM »
how long does the demo version of mach3 lats before  it decides to quit. i am trying to set up my machine with it and can no longer get any sense out of it. 

Pages: 1