1
General Mach Discussion / Re: Mach3 RnR motion card - problem with plasma relay
« on: August 21, 2019, 03:57:33 PM »
I have setup my board like in your picture. I had tried to change the pin number in all of them... Nothing seems to work. It came with a manual but its not for this board...
I will keep trying, maybe i will find some solution... Because for now... Paying 200 euros for a good motion card its not an option unfortunately 😔
I will keep trying, maybe i will find some solution... Because for now... Paying 200 euros for a good motion card its not an option unfortunately 😔