Messages

1

General Mach Discussion / Re: Plasma ignition and stop lag problem

« on: July 08, 2019, 02:43:28 PM »

Hey, many thanks for the propositions and the detailling !

2

General Mach Discussion / Re: Plasma ignition and stop lag problem

« on: July 07, 2019, 08:26:45 AM »

Alright I understand, I've choose this one because I have interferences with my older one, probably due to the USB connection

So let's choose a new controller !

Thank for your help

3

General Mach Discussion / Re: Plasma ignition and stop lag problem

« on: July 07, 2019, 07:08:06 AM »

Hello, thank you for your answers, I come with some (bad) news
I've tried the M11P1/M10P1 but nothing happened, maybe my controller card is not suitable for this command ? I have a NVEM V2 ethernet controller
Maybe I have to configure Mach3 differently with these commands ?

I don't have the THC with my plasma so the option is disabled

I've also tried to play with the delay in Spindle options but I don't understand how the delay "CW Spindle DOWN" work, I thought I can play with it to delay the stopping of the plasma but nothing happened, the plasma stop earlier than I want

Many thank for your help

4

General Mach Discussion / Re: Plasma ignition and stop lag problem

« on: July 06, 2019, 03:13:20 AM »

Thanks for your answer, I've tried to delete all G4P1, the cycle is smallest but I have always this lag. For example, the ignition start between 500ms and 1s before the torch moving, and the plasma stop before the end of the move. As if we have a time lag, in advance to the movement

PS : Sorry if my English is bad

5

General Mach Discussion / Plasma ignition and stop lag problem

« on: July 05, 2019, 04:26:52 PM »

Hello, I come to you because I have a problem and I think it's problably due to my Mach3 configuration. When I start a plasma cutting, the plasma start and stay a moment at the same place before cutting, and it stop before the end of the cutting. I have already set my 4 parameters for Dwell in "Spindle setup" at 0, but nothing change. I think my GCODE is ok, but I let you invoice, just in case.

Thank you !