Messages

1

General Mach Discussion / Re: plasma on off

« on: July 19, 2019, 07:08:42 AM »

Thank you very much guys for your support. I did not know all these.

2

General Mach Discussion / Re: plasma on off

« on: July 19, 2019, 02:36:07 AM »

My Controller Board is Novusun NVUM (6-Axis). I need to connect a Stepper Motor with its driver on Output Pins of the NVUM (look on the Manual). Not in Axis Pins, because I already connect 6 Motors on the Axis Pins.

I need to connect this Stepper Motor on Output Pins of the board, not to use it as an Axis. I want to turn it ON or OFF and to configure its speed.

Is it possible to make the current like Pulses, that goes from the Output Pins of the board to the Stepper Motor Driver, via a custom M command (Macro) ?

Is it possible to configure this Stepper Motor's speed when the CNC is working via a custom M command (Macro) ?

3

General Mach Discussion / Re: plasma on off

« on: July 17, 2019, 06:11:11 AM »

Hello again,

Is it possible to pulse an Output pin (not an Axis pin)?
I mean to make the Current transferred like Pulses (like an Axis Step pin)?

I want to transfer the Current over the Output pin like Pulses, but I don't want to make it like Pulses from my G-Code.
I need the current to be transferred like Pulses automatically.
I use Mach3 (for the time being).

Thank you

4

General Mach Discussion / Re: plasma on off

« on: July 16, 2019, 05:33:43 AM »

Your answers are real lessons. Thank you very much.

What if the Stepper Motor is not connected as an Axis, but it is connected on the Outputs pins of the Controller Board (as a relay to turn the motor on or off).
Will the Feedrate on the G-Code change also the speed of this Stepper Motor?

5

General Mach Discussion / Re: plasma on off

« on: July 16, 2019, 04:08:13 AM »

If a Stepper Motor is connected on the Output ports of a Controller Board (not an Out-of-band Axis) and we change the Feedrate, then the speed of this Stepper Motor will change too?

6

General Mach Discussion / Re: plasma on off

« on: July 16, 2019, 03:10:08 AM »

Thank you very much!! Your information are really helpful.

7

General Mach Discussion / Re: plasma on off

« on: July 15, 2019, 08:38:28 AM »

Hello guys,

Is it possible to add a feedrate on a custom M Command?

I have a stepper motor connected to an Output Pin.
I want to make it turn on (Constantly Rotating) with M122 Command and turn off (Stop Rotating) with M123 Command.
But I also need to add a Feedrate (F Command) that changes the Feedrate only on this Motor to control its rotating speed.

Thank you

8

Finished Plugins for Download / Re: USB JoyPad and game device plugin - New Version 2.0

« on: June 25, 2019, 04:27:39 PM »

Is there any configuration for the plugin to jog both 6 axis with one Joypad (not simultaneously) with different buttons for every axis??