1
General Mach Discussion / Re: Help - Mill not starting anymore. Mach3
« on: June 08, 2019, 03:45:25 PM »
I have noticed under my Ports & Pins in the Input Signals and Output Signals tabs that every has a red X now.
I think this may be why my mill is not receiving output from Mach3.
Trying to figure out now how Input Signals and Output Signals should be reconfigured.
I think this may be why my mill is not receiving output from Mach3.
Trying to figure out now how Input Signals and Output Signals should be reconfigured.