Messages

1

General Mach Discussion / Re: Mach3 X/Y/Z Step Pin & Dir Pin #

« on: May 03, 2019, 07:41:18 AM »

The router is a Maxym 2448 Power Arm Robot, it is driven by 3 stepper motors,  Based on the limited information I was able to find on this machine, I'm not sure that Mach3 will work with the current Machine Control,  I may have upgrade both the machine control, and the software (to Mach3). 

2

General Mach Discussion / Mach3 X/Y/Z Step Pin & Dir Pin #

« on: May 02, 2019, 12:35:10 PM »

I have a older CNC Router (Windows 98) that I would like to upgrade to Mach3,  I downloaded the Demo version and when I went to configure it, it is asking me for Step Pin #, and Dir Pin # (along with Step Port, and Dir Port),  I don't have any information that shows what numbers I should enter here,  is there a way to determine what my current setup is?  I'm not sure how to proceed with this.

Thank You
Pat W.
PDJ Cutting and Fabricating