Hello Guest it is April 25, 2024, 10:40:52 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - samusad

Pages: 1
1
General Mach Discussion / Re: New guy frustration LOL
« on: April 30, 2019, 07:50:15 AM »
I'm using this version AutolevellerAE-0.9.5u2.
can you show me your settings so I can tntar and see if it works with my STB5100 Chinese controller?

2
General Mach Discussion / Re: New guy frustration LOL
« on: April 29, 2019, 05:44:45 PM »
I also was disappointed with my STB5100 card, I tried following the tips of this topic but I was all messed up, I do not understand programming, I used my machine to do the pc with autoleveller and mach3 through the parallel port and XP,
now using windows10 and usb card did not work, please help me with a macro, that can work, until I got the probe down but it does not save anything on the mach3 and when it goes to cut the pcb it's like there is no autoleveller. any point on the board shows the same value as Z

Pages: 1