1
Mach4 General Discussion / Re: Tangential knife Mach 4
« on: May 21, 2019, 04:30:08 PM »
So...I still have the same problem with tangential oscilating knife cutting.
problem ;
when cutting circles in rubber, it seems that it does not finish the circle to the end. It cutts cca up to 355 degrees radius and than stops. Next circle is not corrected, so it starts with 355 degrees (although program says that it is 0) and ends cca 350 degrees and this is only multiplying trough cutting process.....becouse of this problem the circle is widther and widhter and it is not finished at the end....I have to manualy adjust the knife to correct degree...
What could be the problem ?
problem ;
when cutting circles in rubber, it seems that it does not finish the circle to the end. It cutts cca up to 355 degrees radius and than stops. Next circle is not corrected, so it starts with 355 degrees (although program says that it is 0) and ends cca 350 degrees and this is only multiplying trough cutting process.....becouse of this problem the circle is widther and widhter and it is not finished at the end....I have to manualy adjust the knife to correct degree...
What could be the problem ?