Hello Guest it is March 29, 2024, 04:06:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - pcbguro

Pages: 1
1
My Mach3 program has been placed in freehold after a thread break detection and I need to back up my program one line at a time and move the steppers to that location each time I press a button named "BACK 1 STEP".

2
Brains Development / Re: Need someone with brains to help me with mine
« on: August 07, 2019, 08:24:13 AM »
Thank you TPS that works for me.

3
Brains Development / Need someone with brains to help me with mine
« on: July 23, 2019, 10:12:11 AM »
I need help creating a brain that will turn on a relay (output #1) when I press the (Cycle start) button. Then when the program is finished to turn it off.  This relay is used to turn a long arm quilting machine on and off.  I have done it with M3 (on) and M5 (off) by putting it in my gcode this works only if my thread does not break. That never happens it always breaks. So right now when my thread breaks I have to press the manually press the (Feedhold) button to pause the program, then press the (spindle) button to stop the sewing machine.  Then once I have re threaded the machine and stepped the program back some number of steps I need to press the (cycle start) button to continue the program running and then press the (spindle) button to start the machine. I am using Mach3.

4
General Mach Discussion / Re: quilting or embroidery machine
« on: March 18, 2019, 09:37:23 PM »
Larry
I hope that this thread is not dead.  I was wondering if you ever posted the new screen buttons that you mentioned as this is exactly what I am looking for.

Tim (Pcbguro)

Pages: 1