Hello Guest it is March 28, 2024, 11:11:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - WelshWoodcutter

Pages: 1
1
General Mach Discussion / Re: Crashing !
« on: March 14, 2019, 08:27:40 AM »
That's great thanks reuelt.

I now have the machine working, all set up except the jog is very slow. I'll look for a video on it.

Now to find some CAD program that will draw gears among other things that is simple to use :)

Thanks again

2
General Mach Discussion / Crashing !
« on: March 12, 2019, 12:28:28 PM »
Hi Everyone.

OK, I'm new to Mach3. I have a clean 32bit Windows7 machine and have Administrator access. Having downloaded  Mach3 the first few times it crashed but I eventually got it to run, don't know how. I have set all the pins for my 5 Axis Breakout Board and when I restarted back to crashing again :(  After some more  trying I get it going again (don't know how) and run the Driver Test. The Preparation Successful screen come up and then the Take over screen, CRASH ! I tried installing the SpecialDriver but that made no difference, still crash.
 
I did manage to get it working once to the stage where I could manually jog but when connected to my machine it did nothing so I'm guessing the drivers just aren't there. The router does make a few clicking noises as the computer is re-booting so I think they are trying to talk to each other.

The router is all home built following the recipe on YouTube of building a CNC machine for under 900 dollars
The Breakout board is by Savebase.com

Any suggestions would be much appreciated.
Richard

Pages: 1