Messages

1

FAQs / Re: conf. motors

« on: February 17, 2021, 01:13:40 PM »

Glad to help if  I can.  Put the cursor directly over Motor 0, not the check box and left click. It should turn blue and boxes that were grayed out should turn white and let you enter your parameters.

I'm very new to Mach4 and struggling with it. I have been using Mach3 for so many years I find the conversion to Mach4 pretty hard to set up and manuals incomplete.

2

FAQs / Re: conf. motors

« on: February 17, 2021, 01:23:58 AM »

I had the same problem. You have to put cursor on the motor and click. It will turn blue.

3

General Mach Discussion / Mach3 problems with Windows 10 updates

« on: February 03, 2021, 06:49:33 PM »

My Mach3 has been working fine and suddenly won't load G code from Vetric. It works fine on manual and pendant. I read someplace where Mach# won't work beyond Ver. 1709. Wonder if this is the problem as I haven't used machine for about 4 months and windows has now updated to 1909.

4

Building or Buying a Wood routing table.. Beginnners guide.. / Re: x y AXIS ORIENTATION

« on: November 23, 2019, 01:25:53 AM »

My table is 36" long and 17" wide.  When making signs, is most g-code written with X and the long axis or in my case the 36" length?

5

Building or Buying a Wood routing table.. Beginnners guide.. / x y AXIS ORIENTATION

« on: November 20, 2019, 10:55:07 PM »

ADVANTAGES AND DISADVANTAGES OF ORIENTING THE Y AXIS WITH THE LONGEST SIDE OF THE TABLE