1
General Mach Discussion / Pierce delay
« on: February 17, 2019, 01:56:54 PM »
Can anyone get a pierce delay under 1 second, my mach 3 will not respond to anything like .9 .8 .7 and so on.
Only with 1 second or more it reads it.
It was working and reading under 1 second until I installed a smooth stepper.
I have tried checking and unchecking dwell in milliseconds.
I put one second in sheet cam it works I put one second in mach 3 and it works, then I try .9 and it moves the machine instantly, no delay.
I cant be the only one with this problem but looks like it so far.
Help please....
Only with 1 second or more it reads it.
It was working and reading under 1 second until I installed a smooth stepper.
I have tried checking and unchecking dwell in milliseconds.
I put one second in sheet cam it works I put one second in mach 3 and it works, then I try .9 and it moves the machine instantly, no delay.
I cant be the only one with this problem but looks like it so far.
Help please....