Messages

1

General Mach Discussion / Re: Z Axis Feedhold Reverse Run problem

« on: February 07, 2019, 06:11:53 AM »

Hi kanowee can you please explain how and where do I insert the macro in mach3 as I have the same problem as you

Bradley

2

FAQs / Reverse run

« on: February 07, 2019, 06:04:31 AM »

Hi all, I’m trying to do a reverse run in mach3 in order to attempt to go back and try a pierce again, but the problem is when I do a reverse run the z axis moves up and hits the limit switch and there after it takes me back to 0 ,can someone please shed some light on this and explain how the reverse run should be done correctly?

Bradley