Hello Guest it is March 29, 2024, 07:10:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Brendan123

Pages: 1
1
Yes :)

2
Yes. Ive tried reinstalling the licence but it still doesn’t seem to want to go past the 500 lines of code. I really don’t know what else I can do :/

3
Thanks for the reply, I’ve done larger projects in the past and it’s never been a problem. Is there perhaps a way of increasing the tool path ?

4
General Mach Discussion / Toolpath display smaller than my work piece.
« on: January 02, 2019, 04:41:54 AM »
Hi peoples,
I recently tried running a program and the gcode loaded perfectly but the toolpath display only shows a tiny portion of it and once it reaches that point it just stops dead in the middle of my workpiece. My table coordinates are correct and I’ve tried hitting the “regen toolpath button “ but nothing happens. Anyone know what I’m doing wrong? TIA

5
General Mach Discussion / Re: Simplify Screen button "PLEASE HELP!!!"
« on: January 01, 2019, 07:54:39 AM »
AWESOME! Thank you very much. :)

6
General Mach Discussion / Simplify Screen button "PLEASE HELP!!!"
« on: December 30, 2018, 07:10:40 AM »
Hi peoples!
Ive recently re set up my machine and whilst i was configuring a few things i accidentally clicked the "SIMPLIFY SCREEN" button in the bottom left of the screen and now my entire screen is blank! Does anyone know how to "undo" or revert back to what i assume is an "Unsimplified" screen? PLEASE HELP as i am driving myself crazy trying to figure it out. TIA

Pages: 1