Hello Guest it is March 29, 2024, 08:07:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mare

Pages: 1
1
Mach3 under Vista / Re: Mach3 and TB6600 under Win7 cant run motors
« on: December 19, 2018, 09:12:34 AM »
Solved.
I have run again through pin and port settings. Removed all pin settings, restart and set all over again, and it worked. I don't know what was the problem, all setting are the same.
12V are just for testing, setting pins.... while I wait 24V to be delivered.
Thanks joeaverage

2
Mach3 under Vista / Re: Mach3 and TB6600 under Win7 cant run motors
« on: December 18, 2018, 10:09:26 AM »
And just to add...a have noticed that steppers are getting very warm after a couple of minutes power supply is being turned ON. And they don't even work!!!... Is there a powering problem maybe? As I sad, I'm trying to use 12V from ATX power supply.

3
Mach3 under Vista / Re: Mach3 and TB6600 under Win7 cant run motors
« on: December 18, 2018, 09:37:53 AM »
Windows 7 32bit is 100%. I have no PC configuration to install 64bit. Is there any log file of DriverTest that I can attach, or just a screenshot? When I was running it yesterday, on the graph was very little movement. I will post screenshot tonight

4
Mach3 under Vista / Mach3 and TB6600 under Win7 cant run motors
« on: December 17, 2018, 08:27:11 PM »
Hi all!
I've started assembling DIY Cnc mill, and I'm stuck with making my stepper motors to run. I'm using mach3 interface board, TB6600 4A drivers, mach 3 software on windows 7 x86.
Board and drivers are wired like this
https://ibb.co/Lv1QQzd
step and direction pins are set as 2,3;4,5;6,7; e-stop is set active low on pin 15 (if matters).
For power supply I'm trying to use 12v from PC power supply.
In device manager I have some Mach3 pulseing engine driver with question mark, but I'm unable to find the right driver to install.
First time I connected mach3 board I heard relay clicked and 2 leds were lighted. and now only lights one, and other lights only when I disconnect LPT cable.
I have tryed with other PCI card and changing address, and I'm getting green led on driver when pressing arrows, but motor just don't want to move.
Is there any idea for helping me?
Thanks.

Pages: 1